This green LED is operational only when power is applied. The LED will slow blink when the 1000Base-X interface has been taken down as a result of a fault on the 1000Base-T interface. The LED is on when the 1000Base-X link is on and flashes with a 50% duty cycle when data is received. The LED will blink when in Loopback test mode. This green LED is turned on when power is applied to the media converter. Negotiation on the 1000Base-T fiber connectionĪ loopback on the 1000Base-X fiber interface.ġ00-240v AC, regulated DC adapter included In the event that one of the devices becomes Suspends data transmission between two devices Pause signaling is an IEEE feature that temporarily Possibility of lockouts that occur with some Should the partner device on the 1000Base-X be On periodically to allow the condition to clear Is off as a result of this fault it will be turned This provides fault notification to the partnerĭevice attached to the 1000Base-X interface of Receiver is passed to the 1000Base-X transmitter. With Fiber Fault Alert the state of the 1000Base-X This feature can be used whetherįiber auto-negotiation is enabled or disabled. Will reflect the state of the 1000Base-X mediaĬonverter port. Link Pass-Through mode, the 1000Base-T port When the Link Mode switch is placed into Smart The mediaĬonverter can also correct for wires swappedįor up to 64ns of delay skew between the 1000Base-T (straight-through or crossover) and automaticallyĬonfigures the connection when enabled. Interface to determine the type of cable connected The media converter supports auto-negotiation of full duplex, half duplex, remoteįault, full duplex pause, asymmetric pause and Auto MDI-X.Īuto-MDIX (automatic medium-dependant interfaceĬrossover) detects the signaling on the 1000Base-T The switch setting) until the copper is linked Of offline (provided this is enabled through Through negotiation transmitting a remote fault Reached and the copper has linked up with its The 1000Base-X will link up with its partnerĪfter the highest common denominator (HCD) is Negotiates according to 802.3 clause 28 and 40. The 1000Base-X fiber interface negotiatesĪccording to 802.3 clause 37. Gigabit Media Converter Features Auto-Negotiation (802.3ab) These cost and time savingįeatures, along with a lifetime warranty and free worldwide This allows for more efficient troubleshootingĪnd less on-site maintenance. Perle's advanced features such as Auto-Negotiation,Īuto-MDIX, Link Pass-Through, Fiber Fault Alert, and Network Administrators can "see-everything" with Our Gigabit Ethernet to Fiber Converters provide an economical path to extend the distance ofĪn existing network, the life of non-fiber based equipment, or the distance between two devices.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |